Register with Us for Free Training, Technical Information and More…
Download
Your Menu, Drivers and Specifications
Home>Products > CONVERTERS > Unmanaged Media Converter > GIGABIT ETHERNET
 <<Back
CGS3800
GbE SFP To 10/100/1000Base-T/GbE SFP Media Converter
+ High Resolution:  CGS3800

Product Brochure (pdf), 721KB [ Use Adobe Acrobat Reader v7.0 or up ]

TECHNICAL SPECIFICATIONS
  • Model:  CGS3800
  • Standards:
    IEEE 802.3 10Base-T
    IEEE 802.3u 100Base-TX
    IEEE 802.3z/ab 1000Base-T
    IEEE 802.3x full-duplex flow control,
    1000Base-SX/LX
  • Connectors / Slot:
    P1 — RJ-45/SFP Slot *
    P2 — SFP Slot (SFP is a must-have-option!)
    [ * Note:  Dual-Media Port-1 can only use either RJ-45 or SFP slot, but not both at the same time. ]
  • Optional SFP Transceivers (Sold Separately):
    Multi-Mode or Single-Mode (distance: 10~70km)
    Gigabit  Ethernet
    http://www.danpex.com/product.php?cat_id=62
  • Data Transfer Rate:
    10/100/1000Mbps (auto-negotiation or forced mode) for TP
    1000Mbps for fiber
  • Cable / Max Distance:
    50/125µm Multi-Mode fiber, up to 500m (400MHz-Km) or 550m (500MHz-Km)
    62.5/125µm Multi-Mode fiber, up to 220m (160MHz-Km) or 275m (200MHz-Km)
    9/125µm Single-Mode fiber, up to 10~50km (SFP Module dependent)
    Category 5e or better UTP, up to 100m for 1000Base-T
    Category 5 or better UTP, up to 100m for 100Base-TX
    Category 3 or better UTP, up to 100m for 10Base-T
  • Duplex-Mode:
    Full-Duplex for 1000Base-SX/LX/T
    Full-/Half-Duplex (auto-sense) for 10/100Base-TX
  • LEDs:
    Unit — PWR (Power)
    P1 — SFP LNK/ACT (Link/Activity)
    P1 — TP LNK/ACT (Link/Activity)
    P1 — TP SPD (Speed for 10/100/1000Mbps)
    [ Green for 1000Mbps, Amber for 100Mbps, OFF for 10Mbps ]
    P2 — SFP LNK/ACT (Link/Activity)
  • Power Requirement:  0.9A up @ +5VDC
  • Power Consumption:  3.6W
  • Ambient Temperature:  0° to 40° C
  • Humidity:  5% to 90%
  • Dimensions:  140.7 x 87.7 x 29.4mm (H x W x D)
  • Emission and Safety Regulations:
    FCC Part 15 Class A & CE Mark Approval
ADDITIONAL FEATURES
  • Link Fault Pass-Through (LFP)
    With LFP enabled (selectable by DIP-Switch at rear panel), if any segment cable(s) is/are broken, both ports in each converter will be turned OFF, i.e. no Link LED.  If all segment cables are connected good, both ports in each converter will be turned ON, i.e. Link LED.




All rights reserved.  Last modified:  2012-07-06
All information is subject to change without notice.